When will I get the notification?
This notification appears when turning on the device and the Injector is not in the right position. It can also happen if the injector has particles in it.
Types of Notifications
Control Unit
The Control Unit will display a message.
What should be done?
Turn off the device.
Pull the Injector out.
Pliers can ease the process: On the handle, you'll have a little hole- put the pliers in the spot and take out the Injector.
Please notice!
If the injector is stuck inside you can't pull it out. Try to restart the device again and check if you can remove the injector.
If not- you need to contact your pHi-Tech representative to assist\replace the unit.
Do not try to pull it hard.Turn on the Control Unit.
Please Notice the actuator is now sticking out and that the injector is in the right position. Then, put the Injector back inside.
If the actuator is stuck inside, please try to restart the device again and contact pHi-Tech support if it's still not sticking out.
Restart the device and perform one injection in the air to verify the issue is resolved.
If the injector is in the actuator and you are still receiving this message, take out the injector and clean it as described here.
This is how the notification appears in different languages:
AWARIA! WTRYSKIWACZ PODSTAW.
Mal Functionamento! Ger. injetor
НеисправностЬ! Основного блока
Malfuncionamiento! Contrldr d inyector
Arıza! Enjektör Ayarı
Несправність! Упр. ін'єктором1
Üzemzavar! Injektor menedzser
Неизправност! Мениджър инжектор